🔧 PROBE_WAKEUP_TIME_MS 30 for BIQU probes (#28153)

Marlin/src/inc/Conditionals-5-post.h

@@ -3687,4 +3687,10 @@
     #define FTM_BUFFER_SIZE 128
   #endif
   #define FTM_BUFFER_MASK (FTM_BUFFER_SIZE - 1u)
+  #if ANY(BIQU_MICROPROBE_V1, BIQU_MICROPROBE_V2)
+    #ifndef PROBE_WAKEUP_TIME_MS
+      #define PROBE_WAKEUP_TIME_MS 30
+      #define PROBE_WAKEUP_TIME_WARNING 1
+    #endif
+  #endif
 #endif

Marlin/src/inc/Warnings.cpp

@@ -724,6 +724,10 @@
   #warning "BIQU MicroProbe V2 detect signal requires a strong pull-up. Some processors have weak internal pull-up capabilities, so we recommended connecting MicroProbe SIGNAL / GND to Z-MIN / Z-STOP instead of the dedicated PROBE port. (Define NO_MICROPROBE_WARNING to suppress this warning.)"
 #endif
 
+#if PROBE_WAKEUP_TIME_WARNING
+  #warning "PROBE_WAKEUP_TIME_MS has been set to the default 30ms."
+#endif
+
 //
 // Warn users of potential endstop/DIAG pin conflicts to prevent homing issues when not using sensorless homing
 //
@@ -943,6 +947,9 @@
 #if ENABLED(FTM_HOME_AND_PROBE)
   #if ANY(BIQU_MICROPROBE_V1, BIQU_MICROPROBE_V2)
     #warning "Let us know if you experience any issues with BIQU Microprobe and FT_MOTION."
+    #if PROBE_WAKEUP_TIME_MS <= 25
+      #warning "A PROBE_WAKEUP_TIME_MS over 25 ms is recommended with FT_MOTION and BIQU_MICROPROBE_V1 or BIQU_MICROPROBE_V2."
+    #endif
   #endif
   #if PROBE_WAKEUP_TIME_MS < 30
     #warning "A PROBE_WAKEUP_TIME_MS over 30 ms is recommended with FT_MOTION."
@@ -973,8 +980,6 @@
 /**
  * Smooth Linear Advance with Mixing Extruder, S-Curve Acceleration
  */
-#if ENABLED(SMOOTH_LIN_ADVANCE)
-  #if ENABLED(MIXING_EXTRUDER)
-    #warning "SMOOTH_LIN_ADVANCE with MIXING_EXTRUDER is untested. Use with caution."
-  #endif
+#if ALL(SMOOTH_LIN_ADVANCE, MIXING_EXTRUDER)
+  #warning "SMOOTH_LIN_ADVANCE with MIXING_EXTRUDER is untested. Use with caution."
 #endif