THIS HAS NOT BEEN TESTED YET
GBDSO
GBDSO article : http://www.radanpro.com/Radan2400/TestShematics/GameBoyScope.pdf
GBDSO BOM list (2019/02) : https://docs.google.com/spreadsheets/d/1vu9Xc1Mw5STfz_mAsAOrmmyRrHJMRS4_JKM7iif-KBE/edit#gid=0
Max Voltage Ratings
- +/- 16V on 1:1
- +/- 50V on 10:1
Do NOT exceed the max voltage ratings or you risk damaging the cartridge and the Game Boy.
I'm not responsible if you fuck up!
Log file
See LOG.md
Schematic
PCB
Official game cart dimensions
Below you'll find the dimensions for the PCB of an official game (Pokémon Yellow JAP).
Programming the AT27C256R
The first jumper JP1 selects either 5V to pin 2 of the EPROM (VPP) and VPP from the unused 5th edge connector.
The second jumper JP2 cuts the power going to the rest of the board.
While in programming mode, the EPROM needs 6.5V to VCC and I'd rather not have it power to the rest of the board.
To program the EPROM, leave JP2 open and set JP1 so that the edge connector VPP is connected to the EPROM VPP.
When programming is done, bridge JP2 and set JP1 so that 5V go to the EPROM VPP.
GBDSO EPROM to PDIP28
Any decent Universal Programmer should be able to program the EPROM on the cart.
You can see the adapter board on the 3D rendered board above.
The Game Boy connector uses the Xunbeifang GNI172 footprint made by obskyr from the gbdev discord.
You can find other Game Boy connectors made by Gekkio here: gekkio-kicad-libs.
The Xunbeifang GNI172 can be found on aliexpress.
To program the EPROM, leave JP1 open and close JP2 as shown below.
Plug the adapter board into q Universal Programmer and set the target device to AT27C256R.
Note: Not yet tested !
Original GBDSO
Original GBDSO pictures from November 2000 courtesy of Tauwasser on the gbdev discord.
BOM list
Total Price: 31.33€
Total Components: 70
TODO
Change potentiometer footprint to match BOM list component
The potentiometer I bought fits the footprint, so no need to change the footprint.
However, the pot has some metalic piece at the bottom, so you can't have exposed vias beneath it.
I've moved the vias so they wouldn't interfere with the pot.Change orientation of potentiometer on PCB so both are the same
Orientation of pots fixed.