xod/docs/tutorial/21-pulses

title

title
Pulses

#21. Pulses

Note This is a web-version of a tutorial chapter embedded right into the XOD IDE. To get a better learning experience we recommend to install the desktop IDE or start the browser-based IDE, and you’ll see the same tutorial there.

In the tenth chapter, we briefly mentioned the blue UPD input pin and the pulse data type.

This type is very different from all the others. All values in the XOD are transferred to the links continuously, even if the values haven't changed. The pulse data type is different. Imagine something like a flash. It’s basically a message to trigger something else. It does not transmit any data. However, it is useful when you need to convey that an event has occurred or tell something else to work.

For example, say you only want an analog-input node to receive information from a board port at certain intervals, and not all the time. This frequency can be set with the help of pulses.

Each time a pulse arrives on the UPD pin, the node reads the analog port and outputs the value to the VAL pin. This value will be stored there until it changes to another value.

The behavior of the UPD pin can also be set in the Inspector. For a pot the choice means:

• Never: Never produce pulses, i.e. Do not take readings from the analog port at all.
• On boot: Generate a pulse once at startup. We will update the state exactly once.
• Continuously: Generate pulses constantly, i.e. take the readings from the analog port with the highest possible rate.

Test circuit

↓ Download as a Fritzing project

How-to

1. Open the Inspector for the pot node.
2. Change the UPD value to On boot.
3. Upload the patch to the Arduino.

Turn the potentiometer knob and press the reset button on the board itself. Note, the potentiometer updates now only once when the Arduino is turned on.

Next lesson →