RF BRIDGE

Configuration Configure RF code associations for a basic 433 RF recevier, or the device like Sonoff RFBridge 433.

To learn a new code click LEARN (the Sonoff RFBridge will beep) then press a button on the remote, the new code should show up (and the RFBridge will double beep). If the device double beeps but the code does not update it has not been properly learnt. Keep trying.

Modify or create new codes manually and then click SAVE to store them in the device memory. If your controlled device uses the same code to switch ON and OFF, learn the code with the ON button and copy paste it to the OFF input box, then click SAVE on the last one to store the value.

Delete any code clicking the FORGET button.

You can also specify any RAW code. For reference see possible commands for Sonoff RF Bridge EFM8BB1 (original firmware supports codes from 0xA0 to 0xA5).
RF Codes
Transmition
Number of times to repeat the outgoing transmission
Pin configuration
Set to NONE to disable the receiver.
Set to NONE to disable the transmitter.